Bellows Color: Black, Contains Electronic Components: No, Does it require SDS: No, End To End Length: 1125.55, FAA_A1: The Most Likely Cause Of A Power Steering Pump Whine Is Air In The System. The Steering System Must Be Bled. This May Take A Few Attempts Depending On The Design Of The System., FAA_A2: The Geometry Of The Front Suspension Is Designed To Return The Steering Wheel To Center Coming Out Of A Turn. If The Steering Wheel Is Not Returning To Center On Its Own When Coming Out Of A Turn, Check The Front-end Alignment Settings And Inspect For Bin, FAA_A3: No. The Rack And Pinion Has Been Adjusted At The Factory. No Additional Adjustment Is Necessary. Try Isolating The Rack To Find Out Where The Play Exists. If You Hold The Inner Tie Rod And Have Someone Turn The Wheel, Does The Play Disappear? If So, The P, FAA_A4: Yes, The Boot Clamps Must Be Loosened To Set The Toe Adjustment When Performing A Front-end Alignment. Failure To Loosen The Clamps Will Twist The Boots During Turning Maneuvers Causing Cracks To Form On Boot. Once The Boot Is Torn, Road Debris And Water , FAQ_Q1: I Replaced The Rack And Now The Power Steering Pump Is Whining. It Never Did This Before! What Happened?, FAQ_Q2: The Steering Wheel Is Not Returning To Center Coming Out Of A Turn. What Could Be Causing This? , FAQ_Q3: The Replacement Rack And Pinion Is Installed And The Steering Wheel Has Too Much Play. Should I Adjust The Rack?, FAQ_Q4: Are There Any Steps That Should Be Done Prior To Alignment?, Gasket Or Seal Included: Yes, Grade Type: Regular, Inlet Line Fitting Diameter: 0.546, Inlet Line Fitting Gender: Male, Inner Tie Rods Included: Yes, Input Shaft Type: Grooved, Is Item A Chemical: No, Is Or Contains A Battery: No, Is Or Contains A Bulb: No, Is Prop Sixty Five Affected: No, Is the item CARB affected: No, Mounting Brackets Included: No, Mounting Hardware Included: No, Mounting Hole Quantity: 3, Outer Tie Rods Included: No, Outlet Line Fitting Diameter: 0.459, Outlet Line Fitting Gender: Male, Product Condition: Remanufactured, Steering Input Shaft Diameter: 0.734, Total Turns Lock To Lock: 2.5, Type: Hydraulic

2007-2009 Lincoln MKZ Rack and Pinion Assembly (Cardone)

Partslink #: 26-2046

with Hydraulic Power Includes Inner Tie Rods For warranty purposes it is recommended to always install a filter and to use suggested OE Fluid and flush the system In-Line Filter available

$313.20 View part →

✓ In Stock

2007-2009 Lincoln MKZ Rack and Pinion Assembly (BBB Industries)

Partslink #: 101-0228

Power Steering

$327.09 View part →

✓ In Stock

w/o Electric Power Steering

$520.39 View part →

✓ In Stock

2013-2020 Lincoln MKZ Rack and Pinion Assembly (BBB Industries)

Partslink #: 201-0192E

Power Steering

$739.54 View part →

✓ In Stock

2010-2012 Lincoln MKZ Rack and Pinion Assembly (BBB Industries)

Partslink #: 201-0130E

Power Steering Electronic Steering Requires Programmable Module Installation (PMI) per OE service manual or complete an As-Built program

$872.87 View part →

✓ In Stock

2011-2012 Lincoln MKZ Rack and Pinion Assembly (Accudrive Racks)

Partslink #: 5276

When Installing This Rack & Pinion You Must Follow All Factory Procedures For Introducing A New Rack & Pinion To Your Car's CAN Bus System & ECU All Electric Racks Are Shipped w/ Special Packaging To Ensure the Rack Arrives Undamaged. All Of This Same Packaging Should Be Used When Returning the Core. Any Damage To the Core From Handling Or Shipping Will Result In a Reduction Of As Much As $150 From the Core Credit. Please Inform Your Customer When Selling This Rack. Electric Rack