Nissan Sentra Alignment Shim Replacement

Toe Degree of Change 0.40 Degrees (0.20 (in) or 3/16 (in))

Black Full Contact Dual Angle Shim Up to Plus/Minus 1/4 Degree Camber & Plus/Minus 1/4 Degree Toe Cut To Fit

Black Full Contact Dual Angle Shim Up to Plus/Minus 1/2 Degree Camber & Plus/Minus 1/2 Degree Toe Cut To Fit

Green Shim Full Contact Dual Angle Shim Plus or Minus 0.25 Degree(s) Camber, Plus or Minus 0.25 Degree(s) Toe

Green Shim Full Contact Dual Angle Shim Plus or Minus 0.75 Degree(s) Camber, Plus or Minus 0.75 Degree(s) Toe

Black Full Contact Dual Angle Shim Up to Plus/Minus 1 Degree Camber & Plus/Minus 1 Degree Toe Cut To Fit

Black Full Contact Dual Angle Shim Up to Plus/Minus 3/4 Degree Camber & Plus/Minus 3/4 Degree Toe Cut To Fit

Toe Adjustment Plus or Minus 0.10 Degree(s); Nylon Toe Shim

Toe Adjustment Plus or Minus 0.80 Degree(s); Nylon Toe Shim

Toe Adjustment Plus or Minus 0.30 Degree(s); Nylon Toe Shim

Camber Plus or Minus 0.50 Degrees; Nylon Camber Shim

Camber Plus or Minus 0.75 Degrees; Nylon Camber Shim

Toe Adjustment Plus or Minus 0.40 Degree(s); Nylon Toe Shim

Toe Adjustment Plus or Minus 0.50 Degree(s); Nylon Toe Shim

Camber Plus or Minus 0.25 Degrees; Nylon Camber Shim

Camber Plus or Minus 1.00 Degrees; Nylon Camber Shim

Green Shim Full Contact Dual Angle Shim Plus or Minus 0.50 Degree(s) Camber, Plus or Minus 0.50 Degree(s) Toe

M10 x 1.25 x 30 (mm) Hub Bolts Should Be Used When Installing Rear Wheel Shim Full Contact Dual Angle Shim Use with Caliper Shim Spacers If Necessary Yellow Shim Internal Cut To Fit Tabs Check Caliper To Rotor Clearance After Installation