Volkswagen Passat Alignment Shim Replacement

Black Full Contact Dual Angle Shim Up to Plus/Minus 1/2 Degree Camber & Plus/Minus 1/2 Degree Toe Cut To Fit

Black Full Contact Dual Angle Shim Up to Plus/Minus 1/4 Degree Camber & Plus/Minus 1/4 Degree Toe Cut To Fit

Black Full Contact Dual Angle Shim Up to Plus/Minus 1 Degree Camber & Plus/Minus 1 Degree Toe Cut To Fit

Black Full Contact Dual Angle Shim Up to Plus/Minus 3/4 Degree Camber & Plus/Minus 3/4 Degree Toe Cut To Fit

Red Plus or Minus 1.5 Degree(s) Camber, Plus or Minus 1.5 Degree(s) Toe ; Check for caliper to rotor clearance with disc brakes. Use spacer set MS50042 as necessary to keep caliper centered on rotor.

Plus or Minus 1.5 Degree(s) Camber, Plus or Minus 1.5 Degree(s) Toe; Blue Full Contact Dual Angle Shim Allen Head Rear Hub Bolt Set, MS50040 (Pkg 8, M10 x 1.5 x 40mm), must be used with shim. Check for caliper to rotor clearance with disc brakes. Use spacer set MS50042 as necessary to keep caliper centered on rotor.

Plus or Minus 1.5 Degree(s) Camber, Plus or Minus 1.5 Degree(s) Toe; Yellow Full Contact Dual Angle Shim Check for caliper to rotor clearance w/disc brakes, Use spacer set MS50042 to keep caliper centered on rotor.

M10 x 1.5 x 40 (mm) Hub Bolts Should Be Used When Installing Rear Wheel Shim Full Contact Dual Angle Shim Up to Plus/Minus 1-1/2 Degree Camber & Plus/Minus 1-1/2 Degree Toe Blue Shim Internal Cut To Fit Tabs Check Caliper To Rotor Clearance After Installation

M10 x 1.5 x 40 (mm) Hub Bolts Should Be Used When Installing Rear Wheel Shim Full Contact Dual Angle Shim Use with Caliper Shim Spacers If Necessary Yellow Shim Internal Cut To Fit Tabs Check Caliper To Rotor Clearance After Installation