Voice or type your vehicle details and Wrenchy will confirm fitment in seconds.
| Attribute | Value |
|---|---|
| Abutment Clips Included | No |
| Anti Rattle Spring Included | No |
| Bleeder Screw Cap Included | No |
| Bleeder Screw Included | Yes |
| Bleeder Screw Quantity | 1 |
| Bleeder Thread Size | M10x1.5 |
| Bracket Included | No |
| Caliper Color | Red |
| Caliper Finish | Powder Coated |
| Caliper Slides Included | Yes |
| Caliper Type | Floating |
| Contains Electronic Components | No |
| Disc Brake Caliper Casting Material | Cast Iron |
| Does It Require SDS | No |
| Dust Boots Included | Yes |
| FAA A1 | Our Coated Calipers Are Currently Available In Silver, Blue, Yellow And Red. |
| FAA A2 | Not Recommended. The O.e. Manufacturers Specified Steel Or Phenolic Pistons Based On The Intended Use Of The Vehicle. It Is Recommended That The Installer Follow The Manufacturer’s Recommendations. |
| FAA A3 | As A Rule, Always Use Brake Fluid Recommended By O.e. The Fluid Type Is Stamped On The Master Cylinder Reservoir Lid. Always Use New Fluid In A Sealed Container. |
| FAA A4 | Inspect Both Calipers For Binding Or Sticky Slides Or Pins. Also Ensure That Brake Hoses Are Not Collapsed Or Restricted And Inspect Steering/suspension Components For Proper Operation. |
| FAA A5 | Brake Squeal Can Be Caused By Improper Installation Of The Brake Pads, Improperly Installed Brake Hardware And Improper Brake Rotor Finish. |
| FAA A6 | A Symptom Of A Low Brake Pedal Is Usually Caused By Air In The System, Misadjusted Rear Brake Shoes, Deteriorated Brake Hose(s) Or A Defective Master Cylinder. |
| FAA A7 | A Silicone Grease Is Used On Floating Caliper Mounting Pins. |
| FAA A8 | New Hardware Is Included With All Of Our Calipers However The Mounting Bracket Is An Added Option Depending On Part Number And Application. Mounting Brackets Are Also Sold Separately For Most Applications. |
| FAQ Q1 | What Colors Are The Coated Calipers Available In? |
| FAQ Q2 | Can I Switch Out A Phenolic Piston Caliper For A Steel Piston Caliper Or Vice Versa? |
| FAQ Q3 | What Type Of Fluid Should I Use: Dot 3, Dot 4, Or Dot 5? |
| FAQ Q4 | Car Pulls To One Side During Braking. Why? |
| FAQ Q5 | Brakes Squeal All Of The Time. What's Causing The Squeal? |
| FAQ Q6 | Could Calipers Be The Cause Of A Low Brake Pedal? |
| FAQ Q7 | What Type Of Grease Is Used On Floating Caliper Mounting Pins? |
| FAQ Q8 | Do All Of Your Calipers Come With The New Hardware And A Mounting Bracket For Installation? |
| Grade Type | Regular |
| Inlet Fitting Type | Banjo |
| Inlet Port Size | 0.394, 10.00366 |
| Inlet Thread Size | M10x1.5 |
| Is Item A Chemical | No |
| Is Or Contains A Battery | No |
| Is Or Contains A Bulb | No |
| Is Prop Sixty Five Affected | No |
| Is The Item CARB Affected | No |
| Mounting Bolt Included | Yes |
| Mounting Hardware Included | Yes |
| Mounting Hole Diameter | 0.697, 17.69683 |
| Mounting Hole Thread Diameter | 0.697, 17.69683 |
| Pad Wear Sensor Included | No |
| Pads Included | No |
| Piston Diameter | 3.145, 79.883 |
| Piston Material | Steel |
| Piston Quantity | 1 |
| Product Condition | Remanufactured |
| Rust Resistant Coating | Yes |
This part fits the following vehicles:
This is a universal part that fits 1,200 vehicle configurations across 3 makes.
We offer fast, reliable shipping on all orders:
We want you to be 100% satisfied with your purchase. That's why we offer:
This part comes with a limited lifetime warranty. Warranty begins on the original purchase date.
Warranty does NOT cover:
| Brand | Part Number |
|---|---|
| Chevrolet | 18014747 |
| Dodge | 4746355 |
| GMC | 18014747 |
Fits Years: 1988 1989 1990 1991 1992 1993 1994 1995 1996 1997 1998 1999 2000 2001 2002
In operation since 2007. Trusted by over a million DIYers, mechanics, and body shops across all 50 states.
If it doesn't fit, we make it right. No gimmicks, no fine print.
Most retailers stop at 30 days. We give you a full four months to install, test, and return for a 100% refund — return shipping on us.
Brand-new aftermarket parts from trusted suppliers — built to original-equipment specifications so they fit and function like the factory unit, at a fraction of the price.
Ask Wrenchy →