Step 1: Loosen and remove the Phillips screw located on the outside of the turn signal.
Step 2: Using the flathead screwdriver, gently pry the "back-half" of the marker light free of the vehicle.
Step 3: Loosen and remove the Phillips screw that is exposed by removing the side marker portion of the light.
Step 4: You can now pull the turn signal light from the vehicle.
Step 5: Disconnect the wiring harness on the back of the turn signal assembly.
NOTE: If you ordered your replacement turn signal from Go-Parts, it likely includes new bulbs, as most of our models do. This saves you an installation step! However, if your particular model does not, simply turn the socket counter-clockwise, remove the socket from the old assembly, and attach it to the new one. This process only takes a few moments!
Step 6: Connect the wiring harness to the new turn signal.
Step 7: Secure the turn signal by tightening the Phillips screw.
Step 8: Reattach the side marker light by tightening the outer Phillips screw.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: